hostgroups are not shown properly in osd-viz while switching the cluster
1. Navigate to 'WORKBENCH'
2. Change 'SORT BY' to Host
3. Observe the host groups for correctness
4. Switch to a different cluster using the 'Cluster Selector' available in the right-top corner of the page
5. Wait for 20 seconds
6. Observe the hostgroups. They are not shown properly. OSDs are shown as individually rather than as a group
Fix hostgroup issue in osd-viz during cluster switch
In Workbench, when OSDs are sorted based on Host, and if the cluster
is switched, then host groups are not shown properly.
This is now fixed by recalculating the positions of OSD if the cluster
#3 Updated by Christina Meno over 6 years ago
- Status changed from Fix Under Review to Resolved